当前位置：网站首页 > 新闻动态
| 空调维修顺口溜（背诵下来你就会修空调了） |
| 添加时间：2017/9/4 17:34:56 浏览次数： |
| 1：空调制冷不好或者不制冷 1: air conditioning refrigeration is not good or not refrigeration 这个问题最常见空调缺氟是关键 This problem is the most common air conditioning deficiency fluorine is the key 开机先摸回气管通过温度来判断 Start by touching the trachea through temperature 如果冰凉查内机风机转速可能低 If the cold check machine fan speed may be low 内管鳞片和防尘清洗干净或更换 Clean or replace the inner tube with dust and dust 如果内管不算凉粗管可能有压扁 If the inner tube is not cool, the tube may be squashed 回气温度不算凉再摸进气来判断 The temperature is not cool to be judged 进气冰凉还结霜加氟再来试试看 Take a cold and chill and give it a try 结霜如果慢慢散定是缺氟好决断 Frost is a good decision if you slowly disperse 压机老化不难见排气不足是重点 Compressor aging is not difficult to see the exhaust shortage is the focus 四通串气也常见通过收氟来判断 The four-way string is also commonly used to determine the fluorine 高压鳞片必须看脏了也会制冷慢 The high-pressure scales must be dirty and slow to cool 2：压机不启动，温度设置没有问题，但是通电没有反应 2: the press machine does not start, the temperature setting is ok, but the electricity is not responsive 压机不转风扇转一定先把电容看 The compressor must not turn the fan to see the capacitor first 电容鼓包需更换排除电容查供电 Capacitance drum kit needs to be replaced to remove capacitor to check power supply 如有供电查压机过载保护是关键 If there is power supply check the overload protection is the key 没有供电屋内转首先检查连接线 First check the connector without a power supply 其次要把温控看温控最好能更换 Secondly, it is better to change the temperature control to the temperature control 继电器是个重点前面驱动要判断 The relay is a key driver to determine 上述如果都正常下面事情也好办 If the above is normal, it would be better 主板维修或更换询问用户再决断 The mainboard maintenance or change asks the user to decide again 3：空调开机就掉空开 3: the air conditioner starts off and opens 遇到此事先别乱断开外机连接线 Don't break off the connecting line in advance 是内是外好判断判断好了活好干 It is good judgment to judge good job 外机故障事好办四通压机和风扇 The external machine fault is easy to handle the four-way press and fan 依次按个把线断哪个坏了哪个换 In order to break which one broken which changed 最后检查连接线耗子啃了也漏电 Finally, check the connection line mouse and nibble the electricity 内机故障事难办风机风摆先判断 It is difficult to set the wind in the air 拿出主板仔细看看看是否有联电 Take out the main board to see if there is a connection 实在难修板子换把钱赚到是关键 It's really hard to make a lot of money 4：压机启动一会热保护 4: press machine to start hot protection 空调开机有冷风温度随后往上增 Air conditioning starts with cool air temperature and then increases 一会冷风变热风外面压机罢了工 A cold wind will warm the air outside the press 此时先看外风机转速到底低不低 At this point, the speed of the external fan is not low 如果偏低换电容不是电容换风机 If the low exchange capacitance is not a capacitor change fan 其次再看冷凝器如果太脏需清洗 Second, the condenser should be cleaned if it is too dirty 加氟太多电流大压机也会把工罢 Add too much current to the high current press machine will also work 压机电容也要看最好根据原机换 Pressure electromechanical capacity also depends on the original machine change 5：空调不开机 5: the air conditioner does not turn on 空调通电来实验根据嘀声来判断 Air conditioning is used to test the sound of the sound 没有嘀声查供电其次再把主板看 There is no beep to check the power supply and then see the main board 如有嘀声接着判首先按动手起键 If there is a beep, then press the key first 空调启动事好办遥控损坏先判断 The air conditioner starts to do the remote control damage first judgment 排除遥控查接收红外接收先更换 Remove remote control check to receive infrared receiver to replace first 再查是否有供电信号线路履一遍 Check if there is a power supply signal line 然后通电再实验看看空调转不转 Then the electricity and the experiment look at the air-conditioning 如果空调还不转大块损坏至此断 If the air conditioner doesn't turn around the damage is broken 注：大部分空调，通电都会有“嘀”的一声响，但是也有没有的，这个自己来判断。 Note: most air conditioners have a "di" sound, but there is no one to judge. 6：压机通电几秒就保护 6: press power for a few seconds to protect 断开压机供电线外接线路来判断 Disconnect the power line of the compressor to judge 如果正常查供电反之先把电容换 If you normally check the power supply, replace the capacitor first 换了电容再实验如果正常把钱赚 Change the capacitor and experiment if you normally make money 反之再把高压断打开高压再实验 On the contrary, it will open the high pressure and experiment again 如果压机正常转管道堵了是关键 It is critical if the press is properly transferred 如果压机还不转至此就把压机换 Change the press if the press doesn't turn 注：压机保护之后，过载保护器要等一会才会复位，所以立马通电的话，压机是没有反应的。 Note: after the protection of the compressor, the overload protector will not reset after a while. Therefore, the compressor will not respond immediately. |
| 上一页 空调：售后安装行业规则面临突变 |
| 下一页 空调移机步骤及注意事项详解 |
- 版权@盛达嘉业维修部
- 技术支持：保定遨游公司