空调移机怎么回收氟利昂?
How to recycle Freon when the air conditioner is moved?
A、将空调调制到制冷状态下:首先使用扳手将室外机两个连接管阀门的盖子给打开,然后需要使用5个的六角扳手,将其放到细的(高压阀)阀口,然后再阀门迅速的关上,大概20秒过去之后再将粗的阀门(低压)关上,然后才是关闭空调电源,断掉电源。这样做完之后就将氟收到外机中去了。这样就能够进行拆机工作了。
A. Modulate the air conditioning to refrigeration state: first,
open the lid of the two connecting pipe valves of the outdoor machine
with a wrench, and then use five hexagonal wrenches to place it at the
fine (high-pressure) valve opening. Then the valve closes quickly. After
about 20 seconds, turn off the thick (low-pressure) valve, and then
turn off the air conditioning power supply. After doing this, fluorine
is received into the external machine. In this way, the machine can be
disassembled.
B、安装的时候还有开阀门排:具体如下:把内外机固定好之后,把空调连接好,主要是把内外机连接管都紧好,注意一定接好,以防制冷剂泄露。
B. When installing, there are also valves to empty: Specifically as
follows: after fixing the internal and external machine, connect the
air conditioner well, mainly tighten the connecting pipe of the internal
and external machine, pay attention to certain connection, in order to
prevent the leakage of refrigerant.
C.开关打到自动档空调就正常工作,用内六角打开高压阀门(细管阀门),再用六角顶住加氟口顶针(加氟口在低压上),使里面的气体跑出来,10秒钟左右就可以了,不要时间太长,以免雪种跑的太多。这样就可以使管路里面的空气放出来。
C. Switch to automatic gear air-conditioning work normally, with
the inner hexagonal open high-pressure valve (pipe valve), and then use
hexagonal against the fluoride Jack needle (fluoride jack at low
pressure), so that the gas inside can run out, about 10 seconds, do not
take too long, so as not run too much snow. In this way, the air in the
pipeline can be released